Die Cutting

Presentation Folders – Report Covers – Table Tents – Rolodex Cards – Door Hangers
Annual Report Covers – Invitations and Stationery Items – Boxes
… and a myriad of other products!

We are able to glue and fold many of these items on automatic equipment.

Helpful Hints

We are able to do die cutting on press sheets from 3″ x 4″ up to a sheet size of 22″ x 30″.
We must have a gripper edge no smaller than ½”. We can die cut stocks that range from 20# writing stocks up to 25 point board. However, when running the heavier stocks, grain direction is important, so please call before you print. Scoring of stocks less than 3 point is not recommended with rule and matrix systems that we incorporate.

Standard Dies: We have countless standard in-house dies for presentation folders available for your use. We will make any die you require, but the appropriate time must be allowed.

Gripper: We need, in most cases, a minimum of 1/2″ for the grip edge. Also, when tight registration is indicated, you should position the grip and guide as close to the image as possible. Also, never pre-trim a job before calling and talking with us. This avoids registration nightmares for us all.

We need:

• A press sheet
• Artwork
• A spec sheet or a specific requirements description
You must mark guide and gripper on the job. We will run all stock provided to us unless specified otherwise. Please provide this information when placing the order. Contact us for more information on die cutting, foil stamping, and foil embossing.

Back to top